EasyHeat® Warm Tiles® Detecto™ Electric Fault Indicator
Introducing the latest innovation in floor warming technology...
Detecto Electric Fault Indicator for Warm Tiles
The Detecto Electric Fault Indicator is designed to monitor EASYHEAT Warm Tiles Floor Warming Cable and Mat kits during installation. Detecto will immediately sound an alarm if there is damage to the heating cable. Monitors up to three floor warming kits at once.
|
Simply connect to the cold lead.
Remove approximately 2” (5 cm) of the black outer cold lead jacket. Separate the ground braid strands from the leads and twist the copper braid strands together into a wire. Strip approximately 1/4” (64 mm) of insulation from the two lead wires. Insert the black lead into the L1 terminal. Next insert the remaining (white 120 volt or red 240 volt) lead into the L2 terminal. Insert the twisted ground braid wire into the E terminal. Tighten the terminal screws until the wires are secured.
Downloadable files on this page are available in ADOBE Acrobat PDF File format. If you do not have ACROBAT click here to download the latest version of ACROBAT.
Downloads
| Electric Fault Indicator Instructions | |
 |
|
| Detecto™ Electric Fault Indicator Sell Sheet | |
 |
|
| Detecto™ Warranty | |
 |
|